MKII Carrier, 4" Smoke Discharger Info

[Adame]

Hi

I would think that both were not attached at the same time. I have seen factory pictures of both mounts on... but I have not seen one picture of both of them (4 inch and 2 inch)being mounted a carrier at the same time. It would appear to me that the 2" inch mortar replaced the 4" inch smoke discharger. And the simple fact that during the transition of early armour production some MKII* carriers had both holes drill into their armour. I would love to see a picture of both on at the same time.

Cheers
Adam

[Blackpowder44 (RIP)]

[QUOTE=Adame;128817]Hi

I would think that both were not attached at the same time. I have seen factory pictures of both mounts on... but I have not seen one picture of both of them (4 inch and 2 inch)being mounted a carrier at the same time. It would appear to me that the 2" inch mortar replaced the 4" inch smoke discharger. And the simple fact that during the transition of early armour production some MKII* carriers had both holes drill into their armour. I would love to see a picture of both on at the same time.

Cheers
Adam[/QUOTE I bought this carrier from a film hire company and what you see was in it. I should think that this carrier was still in its crate at the end of the war, the build date is Oct. 1944. John.

[Adame]

My Carrier is Febuary 1944, and does NOT have both. I have a 2" inch mortar in mine.

My carrier was released right after Korea in 1953, and has never been touched.

Cheers
Adam

[Blackpowder44 (RIP)]

Originally Posted by Adame

My Carrier is Febuary 1944, and does NOT have both. I have a 2" inch mortar in mine.

My carrier was released right after Korea in 1953, and has never been touched.

Cheers
Adam

I don"t know what you are implying with your capital letters "NOT. I have checked out the bolt holes on my carrier and they are countersunk on the outside and have the correct dome headed, countersunk, slot headed bolts. Being on the outside of the hull means that the bracket would be fitted on the inside and as far as I am concerned this was done in Fords factory in Canada and not done by anyone else. John.

[Adame]

I simply mean my carrier doesn't have it? And my carrier is factory as well.

I wish a Ford designer was around to say why? Or even a memo.

Its one of those puzzles?

Cheers
Adam

[Petr Brezina]

Hi all, would be anyone so kind and measure for me the position of four holes for the smoke discharger on the side armour (Mk.II)? I need to drill them on my project.
Many thanks in advance!

[Ron Pier]

Petr I just measured mine as accurately as I can and drawn the hole centres at actual size on an A4 sheet.

But if you have the bracket? You will only need the top left hole as a datum.

3 3/4" from the front corner of armour and 1/2" from to top. Ron