|
|
|
|
#1
05-02-10, 05:33
|
||||
|
||||
Hi Ian, they will definately have the correct latches on them and I will have some of the rear boxes as well.
Hi Euan, if I can get enough time I will make some drivers tool boxes. It just depends if I can make the die's to produce the hinges but I will do my best. regards Colin. 
|
|
#2
10-02-10, 10:42
|
||||
|
||||
|
Hi everyone, just finished a couple of sets of rear boxes and ready for paint.
also finished a few clips and a pic of the other boxes I have started making for corowa which is the box that holds the stove and the pair of utensile boxes that sit behind the radio. Colin.
|
|
#3
14-02-10, 04:56
|
||||
|
||||
|
Hi all, I have finished the rear boxes and have started making some 2pdr drivers heat shields. I will also have 1 or 2 gear change mechs as well.
Colin.
|
|
#4
14-02-10, 11:06
|
||||
|
||||
|
Heat shields finished. They are fully welded with 25mm thick fibrocement sheeting inside as a replacement for the original aspestos they used back then. I also did the same in my mortar carrier as it is exactly the same and it works a treat, but it does make them quite heavy.
Colin.
|
|
#5
21-02-10, 11:05
|
||||
|
||||
|
Hi all, I have just finished some seats to have at corowa. Left hand and right.
Colin.
|
|
#6
24-02-10, 10:51
|
||||
|
||||
|
Hi all, I will have some gear linkage, possibly all of it if I get time!
Colin.
|
|
#7
24-02-10, 11:02
|
|||
|
|||
|
Colin
Your a machine! If you'd been around in the war, you woulda shortened it! Go and say hello to your wife and kids.. Do they recognise you? (I know they do)
Are you intending to tool up to make tail lights?,...or are they easy to get in Oz?
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
