carrier stowage boxes

[Ian Patrick]

Hi Colin,
Excellent work on the boxes. A couple of questions; Do they come with the latches you showed being manufactured in your other post? Will you also be making the three smaller boxes that mount in the rear compartment?
I'm definately interested in a set. I'll send you further detailis in a PM.
Thanks.
Ian

[Euan McDonald]

Colin, as usual top quality work. Like Ian I was wondering when you are reproducing the drivers tool box.

[colin jones]

Hi Ian, they will definately have the correct latches on them and I will have some of the rear boxes as well.
Hi Euan, if I can get enough time I will make some drivers tool boxes. It just depends if I can make the die's to produce the hinges but I will do my best.
regards
Colin.

[colin jones]

Hi everyone, just finished a couple of sets of rear boxes and ready for paint.
also finished a few clips and a pic of the other boxes I have started making for corowa which is the box that holds the stove and the pair of utensile boxes that sit behind the radio.
Colin.

[colin jones]

Hi all, I have finished the rear boxes and have started making some 2pdr drivers heat shields. I will also have 1 or 2 gear change mechs as well.
Colin.

[colin jones]

Heat shields finished. They are fully welded with 25mm thick fibrocement sheeting inside as a replacement for the original aspestos they used back then. I also did the same in my mortar carrier as it is exactly the same and it works a treat, but it does make them quite heavy.
Colin.

[colin jones]

Hi all, I have just finished some seats to have at corowa. Left hand and right.
Colin.