|
|
#5
15-01-10, 17:44
|
||||
|
||||
Hi Kevin
Ok got the holes measured up Going from the back steel plate towards the front. The first hole is 4-1/4" to its center. The second hold from the back plate is 15-1/2 to its center. The are 7/8 in from the inside edge. I can't remember if it was the center of the hole or not. However the holes are offset to the outer edge. The hole diameter is 3/8" Hope that helps.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer Last edited by Jordan Baker; 16-01-10 at 16:56. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode