|
|
|
|
#1
13-04-09, 11:06
|
||||
|
||||
bearings
These are the bearing sets UPTONS of Corowa had .... I must have bought 15 setsas they were very cheap .... still have to work out which 216 they fit , the old chap there , Mr. Upton said they fit 216 Chevs. There was a large box of them, many packets had broken open and individual pairs were scattered around the box and floor. I asked how much for the whole lot and was told $150 or similar .
Mike
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad Last edited by Mike K; 13-04-09 at 12:58. 
|
|
#2
13-04-09, 11:39
|
|||
|
|||
|
nasco bearings
Mike
If you send me the pt numbers of the indivdual packets I have a Nasco parts book and should be able to I.D them . Regards Jim S.
__________________
jim sewell cmp and cckw
|
|
#3
13-04-09, 12:56
|
||||
|
||||
|
numbers
jim
Would you believe the area on the box where the number should be is blank ! the shells have numbers on them, very small. some are: 5246988........looks like rear main 5246980 the thrust flanged centre shell the other two narrower shell sets of the four dont have a number The main box has M31155 on it , this has been edited to M31136 in pencil
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad
|
|
#4
13-04-09, 14:05
|
|||
|
|||
|
nasco
Mike
These numbers do not show up in my book which goes up to 1954 , will try and find a later book that has the set part numbers ie, M 31136. Regards Jim S.
__________________
jim sewell cmp and cckw
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
