|
|
|
|
#1
14-02-09, 17:07
|
|||
|
|||
Bracket ID
Sir,
The 2 little brackets with puny sheet metal stampings are to hold the front of your seat frame to the floor. I know that a couple of 1/4" bolts seems like overkill, but that is what was used at the front. The seat slides into a much wider bracket for the rear of the seat, then those 2 small tabs hold the frame down to the floor. You are indeed missing a strap that connects the lower tubes of the seat frame. These must have been welded on the afternoon shift, beacuse mine fell of also. Or maybe just a fat guy leaned back too far - this also happened to my '03 Silverado  .Good luck. Stewart 
|
|
#2
14-02-09, 18:11
|
|||
|
|||
|
Who was......
... the fat guy in the 03 Silverado.....?
That Ford gun tractor seems to have a access panel in the floor behind the seat.....?.... maybe the guys frome Petrolia would know..... Eric.... will send photo of the missing strap...... easy to make and weld back in place....... Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada
|
|
#3
14-02-09, 18:14
|
||||
|
||||
|
Hi Bob,
That is not on a gun tractor but on the ford F15a i think is for a gaz can Call me i home 
__________________
Eric Thibodeau 1942 willys Jeep
|
|
#4
14-02-09, 20:30
|
|||
|
|||
|
On all the NZ based CMPs I've seen,
Those little brackets hold down the back of the seat frame which extends about one inch each side, and the wider bracket holds the front edge of the seat base, out of sight under the seat itself.
Could the window frame be from a HUP rear door? Does the floor bracket behind the seat have a raised edge? Hard to see clearly in the image. I usually stow stuff behind the seat, but things can roll or slide while driving, so a shallow box would be a useful modification. My C8AX has a raised angle frame fitted on top of the doghouse. Very useful to hold small bits and pieces on trips. Rob
|
|
#5
14-02-09, 20:44
|
||||
|
||||
|
Those little brackets hold down the back of the seat frame which extends about one inch each side, and the wider bracket holds the front edge of the seat base, out of sight under the seat itself. Any pic????????
Could the window frame be from a HUP rear door? it come frome a C60L Does the floor bracket behind the seat have a raised edge? Yes Rob
__________________
Eric Thibodeau 1942 willys Jeep
|
|
#7
15-02-09, 11:38
|
||||
|
||||
|
Thanks Jim for the pic
 Any one for the back bracket or the window frame  For the plate in the floor i think is the battery holder home made 
__________________
Eric Thibodeau 1942 willys Jeep
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
