|
|
|
|
#1
31-01-09, 04:09
|
|||
|
|||
carrier armour
The sides and back armour is 8 mm
All the front is 11 mm the divider behind the driver is 6 mm the rad cover is 8 mm back and sides with the top plate at 6 mm The bent angle iron to put these peices together is 3 mm the engine covers are 2 mm .This my be not exact but it is close as mine still has the orignal paint on it .If you do a front end you should look at one first as it is a difficult thing to do .On some of my joines they shaved some off to get a fit . George
__________________
George is hooked on OD 5 window DT969 8 ton Fruehauf trailer M2A1Halftrack ,CMP #11 F15A1 #13 F15A1 RAF Fordson Tractor, 42 WLC HD No.2MK11 CT267514 center CB24713 bottom hull25701 ,No.2 MK2 parts MK1 10128 ,(2) MK1 ,Parts Hull9305 .Hull 10407 Hull plate # 7250 all have walk plate on back steps 1917 Patent modle amphibious army tank 
|
|
#2
11-10-09, 06:02
|
|||
|
|||
|
I am looking for the measurements of the vision slots in the front armor. If someone has them please post them here or p.m. me with them.
Thanks, Ron
|
|
#3
23-12-20, 17:37
|
||||
|
||||
|
Hello
I am happy with the very helpfull plan put in line By Jordan, But they are hard to read , did someone have them in better picture quality? Best regards Sylvain
|
|
#4
23-12-20, 19:51
|
||||
|
||||
|
Certainly, they were made into CAD files I believe.
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#5
05-01-22, 23:57
|
|||
|
|||
|
Need ducting and engine compartment measurements
Hi all,
I am also in the process of constucting all upper armor for my carrier. Most of that work has been done and now moving onto the interior. I need ducting and engine compartment measurements. I have side covers to measure off but don't know the measurement of top plates of housing and of the air ducts. PS anyone has spares of steering bellcranks and linkages would be great too. Picture attached of work so far. Thanks.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
