Wanted: RT-524 Mounting Shelf

[Scott Bentley]

Originally Posted by Eric B

Hello Scotty

I have seen both styles of radio trays being used with the M151A2's. The box style as well as that shown mounted under the box.

In our Militia Infantry unit we just used a PRC 77 radio over the back of the drivers seat with the antennae hooked up to the vehicle mast, or the portable units antennae stuck out the drivers side curtain.

The box style tray in the M151A2 in Gagetown photos shows the Vinson Ecryption device mounted on top.

From my reserach this would have been a MT4626 mount. However there seems to be a shock system underneath it while the US mounts i have seen where mounted directly to the box. Can anybody clarify this or correct me if i am wrong? What were the shocks? Did we take them off of the radio power trays?

Thanks
Eric

I almost landed a find on an extra MT4626 from a collector out west. Turns out he had no extras after all, but he might be able to get you a good close-up picture. He has it mounted in the same manner as that Gagetown MUTT in the top photo, but in an Iltis. Not sure about the Isolator/Shocks, I never thought to ask.

I'm pretty much set on going with the Cabinet Mount for my 524. As you had mentioned before, the Sub-Tray Mounting Plate for the whole unit is where the hunt will be.
Looking at pictures of the Iltis Sub Tray, it hooks into mounting rails in the bed of the trunk, and doesn't look like it would work. The US M151A2 specific Sub Tray, although probably different from the Canadian one, looks like it might work in a pinch.

Lastly, since I have two NOS Tops, i'm debating on using an AMU Utility Mount on the ROPS and modifying the Top, instead of going with the M38A1 Extension Mount. Did the CF cut holes in the Tops to fit over the Bracket back when they were in service?

Thoughts on that?

[Eric B]

On the M151 photo requests there is a M151 with the radio antennea mounts attached to the roll cage through the top.

I know i can get the MT4626 trays from the US, but they do not have the shock mounts as used on the CDN Mounts. Close up photos of these would be great.
Only The Iltis radio box itself will fit. The earlier Iltis mounting tray will not work.

Have a great Holiday.
Eric

[Alex Blair (RIP)]

Stew..
Boobee is heading to NB this month and for a fuel donation may be able to bring them back..Work on it..

[rob love]

I just saw some of those bottom plates out at the military scrapyard today. If you still need one, let me know for next time I am out.

Rob

[Scott Bentley]

Originally Posted by rob love

I just saw some of those bottom plates out at the military scrapyard today. If you still need one, let me know for next time I am out.

Rob

I managed to get my paws on 2 of them from Niagara Military Parts a little while ago, but i'm sure there are some folks looking for them, as they seem to be getting scarce.

Thanks Rob

Scotty