article on tyre tread patterns

[Lang]

Originally Posted by Keith Orpin

Hi Hanno,
Nice article, the British actually marked their Chevron pattern tyres with an arrow, to show the direction of rotation. This shows the open end of the V striking the ground first, which is completely opposite to the way the Canadians show it in their manuals. Having stated that, driving my Chev with the open end of the V striking the ground first, makes it slightly easier to handled, than with the closed end hitting the ground first. I was told years ago, that the reason for mounting the tyres with the V striking the ground first, was that if you became stuck, you could always back out of trouble, which is hardly going to affect us on todays roads !
Regards
Keith

Keith,

Most of the original directional tyres I have seen actually had two arrows, "Driving" and "Rolling"

I have a 1944 Australian Army TM (which is just a reprint of a US Army TM with a different cover) on "Care and Maintenance of Rubber Tires". It says all tires should be fitted with open side of "V" striking the road for vehicles used on formed surfaces. Up to 20% greater life can be expected. For vehicles used off road the rear driving wheels should be fitted with the point of the "V" striking the road. A considerable increase in traction on soft surfaces has been demonstrated by this fitment. Only wheeled armoured vehicles should have all wheels with the point of the "V" striking first at all times.

Lang

[Mike K]

No, Im not asking tyres out on dates...

On today's tyres.. among other sidewall markings you'll see a date code .. typically 4 numbers like for example: [1307] this number = the tyre was manufactured during the 13th week of 2007 . I checked my MRF 900 - 13's, and they are dated 2002 . I also have a few OLYMPIC 900-13's dated the year 2000 .

Recently, there has been a few cases of tyre retailers selling tyres which are way past the 'use by' date ... Apparently, more than 6 years old , is considered to be a non-roadworthy tyre here - they reckon the compound dries out .. leaving it prone to disintegrating under high speed.

Mike

[Lang]

Originally Posted by Mike Kelly

No, Im not asking tyres out on dates...

leaving it prone to disintegrating under high speed.

Mike

A Morris or 8cwt blitz at high speed?

[Lang]

I found another manual "Maintenance and Care of Pneumatic Tires and Rubber Treads" TM31-200 April 1, 1943

Quite thick and has vehicle and aircraft tyres, half-track treads and tank tracks including detailed repair and fitting instructions. Big charts of tire pressures for each size and vehicle type etc.

Lang

[Alastair Thomas]

I have been reading "Design Record Canadian-Developed Military Vehicles World War II". This is a summary of the experiences and design decisions made during the CMP program. It is in 8 volumes and in volume 4 tyre production, size choices and wear considerations are discussed.
Firstly the loss of the major rubber producing areas is discussed. This was a serious enough situation for a number of hitherto rubber parts (including the windscreen blocks on the Jeep and motor bike twist grips) to be made of alternative materials. It may be that the transition from rubber boots round the levers in the CMP cab changed from rubber to canvass at this time for the same reason. Then the topic of which way round to mount the tyres is introduced. Though specific instructions were issued one is left with the feeling that they were not strictly adhered to.
Alastair
F60S

[Jacques Reed]

Good Day,

Here is a reprint from The Australian Monthly Motor Manual 1946 which may be of interest. It was reprinted in the VMVC Newsletter many years ago.

In the article fitting of "Chevron Tread" tyres goes with the open end contacting the ground first for better longevity but admits some loss of traction.

Cheers