Seat details for McDells

[Jordan Baker]

Here are some pictures for you.

The seat is 14 1/2" wide by 25 1/2" tall.

The spacing for the top and bottom Dot fastners is L-R 1 1/4", 5 1/4", 9 1/4" and 13 1/4"

The sides T-B are 5 3/4, 10", 15" 1/4", 20 5/8"

The identation from the sides of the wood is done by lining up the outer edge of the actual fastner on the cushion with the edge of the wood. The pictuers show this better then I can explain.


The plywood is 5 layer and 3/8" thick. The corners are slightly rounded and not a sharp square. The last 3 pics are ones I have on file from the internet, they show the part number painted on and also stamped into the wood along with an intact original seat cushion.

I will get the measurments of the back brackets and placements tomorrow. John Bizal at Midwest Military makes the lower "hook" brackets. If your making 2 seat backs then you'd need 4 of them.