|
|
|
|
#1
13-08-08, 11:19
|
|||
|
|||
Thanks guys for the drawing and pictures much appreciated.
Darron 
|
|
#3
16-05-09, 00:52
|
|||
|
|||
No photo Harold,
The Bren is held by the front mount pin under the gas cylinder, and by friction at the rear of the mount, where a spring steel piece grips the receiver.
The mount hangs inside the front plate, to the right of the firing slot when not in use, or if a Vickers is fitted. Rob Brent I think the Canadian mount is similar to the small cast mount that you see inside the front plate of a mid production LP2A as shown in Jeff Plowman's first NZ Armour book. There was a 'U' shaped piece of steel bolted inside the firing slot to narrow the opening for the Bren. Rob
|
|
#4
16-05-09, 06:55
|
||||
|
||||
|
I'm not an expert at Photoshop, but this shows the relative position of the mount to the Gun.
|
|
#5
28-09-13, 03:52
|
|||
|
|||
|
Hi Fellows
This cradle is the same to use in a Carrier T16?   Thanks in advance! Regards
__________________
Mariano Paz Buenos Aires, ARGENTINA 1944 Ariel W/NG 1945 FGT FAT Last edited by m606paz; 28-09-13 at 04:24.
|
|
#6
28-09-13, 11:54
|
||||
|
||||
|
Brit carrier use.
I have seen this mount in use on Brit built carriers. Pic attached of early Bren Carrier.
kevin.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
