LP2A found and recovered

[Justin Pollard]

Hello Rod,
Yes its unreal that there are still some out there like this,But there are going to be less and less with the scrap dealers pushing the way they are.so nows the time to be saving them.
Heres a pic of the inside front now that i,ve cleaned four inches of dirt out.

[Eric Szalanda]

Justin,
good to see that you got one. Typical rusted out floor.
I am in the process of fabricating new seatmounts, pedal mounts and control pivots. The seat mounts are the same as the English carrier, but I doubt that there aren't many of those around either. The pivots are uniquely Australian though. They will have to be turned and threaded. Unless I can find a suitable stepped bolt.

Good luck.

[ron]

Hi Justin,
When you get a chance could you have a look at the front tow eye and tell us what number is stamped on it please? On other carriers other than Met gas this number is the tow eye part number, but on Met gas ones it is not I believe it may be an assembly number I have looked at a few of them and they are all different, maybe anyone else out there could check their Met gas carriers its annother piece for the puzzle,
Regards, Ron

[ron]

Hi Eric,
Here is a couple of shots of old and new mounts ,Its much easier to make new ones than bother with the old rusty stuff that is too far gone,
Do you have any pics of your progress on the british carrier yet ?
regards, Ron

[ron]

Hi Justin,
Just a little hint for you,I suggest that when you start to rewire your carrier that you do it before you fit the air scoop,the job is so much easier without it being in place in fact its better to do it before anything else is fitted in either the front compartment or the rear, also here is a pic of the steering cam plate and new rollers and main cross shaft fitted into place jus to test the operation of the cross shaft,
Regards, Ron

[Justin Pollard]

Hello Ron,Thanks for that info.
The number on my towing ring is 422.
I also found some stencilled numbers on the Bulkhead behind the seats,but on the other side and covered by the air scoop,cant really make them out but they are in black.i took a pic but didnt come out real well,has any one else seen this?.
They would have to be done when it was being built.

[Justin Pollard]

Hello Eric,I,m very happy with my find,and thanks for the info.
The floor has some pretty bad pitting but nothing that will give me to much grief.