Reference: Plans How to build a tool box for a CMP truck

[Mike Timoshyk]

Well I am just in from the garage. Still snowing....

I finshed making the final cuts to the bottom of the box and proceded to use the glue to put the bottom in the box. After it is set and dry I will do a few welds here and there. I placed the top on to get the correct distance between the two sides. It is not on there permanently yet. Tomorrow I will take the top off and insert the partition and the one inner brace. These will also be glued in with just a couple of welds afterwards. Then I will fabricate the lids and doors and the weird angle piece for the ends.

for now...

Mike in Windsor On