Exhaust system question

[c. ladouceur (RIP)]

Chris,
Thought I might throw the question out there on the chance that some other ," hoarder", might have right side mufflers. I've gone to several," specialty", muffler shops,but they all say the bends are too tight-I could do them one at a time using sand and a torch,but no two would look the same,LOL. Have been quoted prices of $40-$50 to bend and weld if pipe sections could be made to specs. I might try to cut a left hand pipe ,(at two locations ), and twist and weld in a jig made from a good used pipe end,(left hand). Trying to avoid doing it myself.
Cliff.