I was able to use the new brass wire wheels to final polish the Left Coil Case Mounting Plate and hardware, acid etch and rinse it all and get into the electroplating solution for a new coat of zinc. My 2-Amp 12 volt trickle charger was getting quite. workout with such a large piece, so after an hour, I switched up to my 10-Amp charger for another two hours last evening, rinsed the plate assembly off and let it dry overnight. Blew through one brass wire wheel getting it done but expected that, given the size of these plates. Great to be able to just pick up another wheel, swap it in and keep right on working.
This morning I was able to reinstall it on the case and now I am ready to repeat the process with the mounting plate assembly for the right side of the case.
29-12-24, 21:37
COIL, Aerial Tuning No. 2 A. ZA/CAN 4725
Similar Threads
Threaded Mode