Wireless Set No. 52 Canadian - Project

[David Dunlop]

The weather is still not great for yard chores, either too hot or just enough wind/rain to shut various projects down, so I was able to work on the Spare Parts Case and finished off the initial cleaning of all the metal hardware by completing this work on the bottom and front of the case this morning.

Good thing I had left the front until last. I had done this because cleaning the two latches is very fiddly work, but on this case, I discovered a layer of heavy tan yellow paint had been applied to the front and it covered all the metal hardware. I like getting the bulk of the old paint off the hardware by hand. It is time consuming, but saves a lot on wire wheels for the Dremel. Once the woodwork on the case has been sanded and repaired, where necessary, I can give all the metal parts a quick final clean with the small wire wheel and everything is ready for priming and painting a new Flat Olive Green top coat.

The Spare Parts Case is dimensionally larger than the Tool Box on all three axes, but carries an overall lighter load, being predominantly spare valves, fuses and light bulbs for the main 52-Set. Consequently, Canadian Marconi saved themselves some money by using the identical hardware items on both the Tool Box and Spare Parts Case: handles, latches, hinges and corner guards.


David