|
|
#2
23-11-22, 18:25
|
|||
|
|||
I'm working on the museum's Cdn2 right now, and it has the splash shield. The shield is held in place by two bolts on the top wheelwell, one bolt near the floor on the inside, and a bolt running through an L shaped bracket off the upper reflector bolt.
After nearly 20 years of service, the bolts would often break and the plate would then get discarded. We weren't so religious about using antisieze back then as we (I) are today. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| M38A1CDN2 rear light | Retsarge | Post-war Military Vehicles | 2 | 04-11-22 00:13 |
| MkI* U.C. (Canadian) rear panel holes | Lynn Eades | The Armour Forum | 12 | 30-09-18 04:09 |
| Iltis rear quarter panel restoration question | Stuart Fedak | The Restoration Forum | 6 | 09-09-12 22:37 |
| For Sale: Brand New Left rear tail light assmebly for M series | Casey B | For Sale Or Wanted | 0 | 15-05-12 05:56 |
| M38A1CDN2 vs CDN3 rear axle ass'y | chris vickery | Post-war Military Vehicles | 6 | 12-08-11 16:12 |
Threaded Mode