|
|
#11
18-01-22, 06:21
|
||||
|
||||
I made a couple of small jigs to make fuel line stays. I used fibre board so as to not mark or distort the brackets and a slotted piece to put the formed clamps in and then in the vise to hold together while I drilled the hole. In this way it doesn't leave any sharp swarf pieces and every one is drilled in the same place. I have bent the 5/16 Bundy fuel lines for each tank and both are also fitted to the underside of the top plate. A test fit of the Ammo holder bins as well. All in all has been a productive day.
Last edited by colin jones; 18-01-22 at 06:58. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |
Threaded Mode