|
|
#11
20-10-20, 00:46
|
|||
|
|||
IRONS, Soldering, Electric 12 Volt, 100W No. C1 ZA/CAN 4778
Lacking any Instruction or Operating Manual information whatsoever for this tool at the moment, leaves me wondering if, and how well, it would have worked, if connected to a wireless battery? Would the current load of heating up the tip coil be detrimental to a wireless battery, or could that risk be negated if a chorehorse was charging the wireless battery system at the same time the soldering iron was being used?
Would the soldering iron have to have been connected to the battery directly, or could it simply be clipped to available +/- terminals somewhere on the wireless vehicle charging/power distribution system? Or could it even be clipped directly to terminals on a chorehorse, or larger, generator? David 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian staff car wireless: World War 2 Canadian R103 Receiver Demo | Mike K | The Wireless Forum | 5 | 24-07-16 15:20 |
| Found: CMP Wireless body project | Jim Burrill | For Sale Or Wanted | 7 | 05-04-15 00:02 |
| Canadian dehavilland mosquito restoration project | David Dunlop | WW2 Military History & Equipment | 9 | 10-07-14 00:51 |
| Canadian project | David Ellery | The Carrier Forum | 9 | 28-04-07 01:36 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 00:11 |
Threaded Mode