Getting the front panel of the Sender to a point where I can clean it is a slow process. Some screws break free easily and some fittings slide off easily. Then you run into grub screws, set screws and knobs that do not want to budge without a soak of cleaner and or light oils. The current delay is freeing up the PA TUNE Knob from its brass shaft.
A good play is also helpful when doing a tear down. From working with tuning dials on 19-Sets, I remembered it is always a good idea to orient the main dial knobs in such a way that the set screw can be easily accessed with a screw driver. Adding to the mix with the 52-Set Sender is the fact it has three large dial assemblies spaced across the front of it. For disassembly, the Flick Control Levers must be in the "SET' Position, with the set screws facing to the right. That means one must disassemble each dial assembly in sequence, from right to left across the front panel.
As I remove parts, they are all being tagged and bagged with their respective hardware and placed in a bin.
I am never keen about this phase of a restoration. Whatever you are working on progressively looks less and less like what it should, and in some cases can end up looking like something even the local scrappie would run away from.
David
|
19-03-20, 01:55
Similar Threads
Threaded Mode