Wireless Set No. 52 Canadian - Project

[David Dunlop]

I had to take a break from oscilloscope work this week as my head was starting to spin, and I think I was also developing a mild case of 52-Set Withdrawal.

I decided to try a little more hand polishing to remove more of the yellowed varnish top coat on the Sender panel. A simple half hour of freehand work without work lights. I tackled the lower right quadrant of the sender fan door assembly, where I had earlier removed a set of red numbers. (See Posts 201 and 228).

The polish cloth was coming away with quite a brown tone to it as I worked, but the colour did lighten up quite a bit and when the time comes to clean the Sender panel, I think I should be able to get a very close match to the upper portion of the Receiver panel.

The other little bit of excitement was the arrival yesterday of a second Cases, Spares Box for the 52-Set.The interior KimPaK lining in this one is as close to mint as one could hope for, compared to my other box. (See last photo Post 168). Restoring/replacing that lining was going to be a major challenge, so I was pleased to cross paths with this one.

This box also underwent a NATO conversion on the outside and I will be surprised if any original stencil markings show up. But I will take a careful look...just in case. The exterior of the box was sanded and NATO Greened, and then a large patch of tan paint was slapped on and NATO stencil ID's added in black. It looked so garish, the previous owner toned it down with a uniform coat of green paint.

David