#1
|
|||
|
|||
Digging a Hole
This may be a bit of a spotter question but I have been trying to track down a Canadian Entrenching tool similar to the one in the picture for a webbing set.
I have a Canadian cover but all the tools you see seem to be British made. Did the Canadians make them or did they just use the British ones? If they did make them is there a list of manufacturers anywhere ? Any guidance would be appreciated there seems to be very little in print on the subject Thanks Richard |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hole Pattern Layout | Andrew Rowe | The Carrier Forum | 0 | 19-04-14 23:20 |
hole in seat? | carrierbarry | The Carrier Forum | 20 | 16-02-14 05:07 |
I was just digging the back vegetable garden ... | Robert Dabkowski | The Armour Forum | 0 | 11-02-08 15:00 |
Drilling big hole through steel plate | Jordan Baker | The Restoration Forum | 12 | 17-02-06 05:30 |
LP2 Hole ? | Graeme Stephens | The Carrier Forum | 3 | 18-08-05 17:25 |