|
|
#31
27-06-18, 01:17
|
||||
|
||||
All my new bearings arrived yesterday so I made a quick run to the USA to pick them up. All went smoothly crossing the boarder both coming and going and I was home in no time.
Today I began disassembling the shafts and gears to clean them up. All has gone well except for the idle shaft. I don’t have the special tool for removing the speedometer gear. It’s tool J1737. I suspect it is simply a tool shaft that has matching female threads of the speedometer gear to screw on. I did try a bearing removal tool and it chipped part of it. I’m not sure if I’ll need to source a new one or not. I believe the GM# is 1811722 I see from the LWD site they have a Ford part that looks the same. Part # C01Q-17285-A. Does anyone know if they cross over?
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode