![]() |
#20
|
|||
|
|||
![]()
I looked at about 10 Chevrolets today (C15A to C60L), only one had a hole similar to the one shown in post 12 and that hole looked as if it might have been a modification, not on production.
The first photo shows the only crossmember with a hole in the given location. You can see that the winch blocks anything passing through the hole. Teds winch.jpg The second photo is of a C60S tipper. The transfer case mounted PTO can be seen through the winch hole in the crossmember. C60S tipper PTO.jpg The third photo is of a typical crossmember in the group checked today. Crossmember.jpg The fourth photo is the same truck as the third photo, taken from below the frame. Again, the upper shaft of the transfer case can be seen in the opening of the crossmember (no PTO, it is a single speed case). The location where a transmission mounted PTO would be fitted can be seen just to the right of the muffler. Although the smaller hole shown in post #12 is roughly in line with the transmission PTO, it seems a little unlikely that a shaft from the PTO would be angled up that high to drive a pump but I do not have a water bowser to compare this to. view forward 1.jpg Last edited by Grant Bowker; 15-04-18 at 03:36. Reason: To make desriptions match photos. |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Info needed: Chev Blitz 1943 C15A Wheels | Andy Klarenbeek | The Restoration Forum | 2 | 29-12-16 02:16 |
Heads Up: 1943 c15a | Ian Johns | For Sale Or Wanted | 1 | 05-05-16 20:15 |
1943 Morris Commercial C8 4x4 GS project | svdwal | The Restoration Forum | 25 | 13-07-15 19:54 |
My New Project C15A Water Truck | Ian Johns | The Restoration Forum | 60 | 21-07-14 20:17 |
Engine color - C15A - 1943 | Svenn Ryen | The Softskin Forum | 4 | 06-04-13 23:49 |