|
|
#33
08-06-17, 07:52
|
||||
|
||||
Tonight I finished (not this late but much earlier) the welding of the top channels on the side and front panels for the box. It worked out to approximately 80" of weld for a butt joint. Other then taking a while as I had to wait for the each pass of welds to cool before moving on, it went really well. Many clamps were used to hold the panels down flat to the work bench. I then went back with a flap disk and cleaned down the welds and blended them into the surrounding metal.
Tomorrows (todays now due to the hour  ) plan is to finish the front panel and start in on the sides.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode