11 Set stuff

[cletrac (RIP)]

I finally found a picture of an 11 set with a calibration tablet in place then checked the holder on my set for size. The tablet would be 1 1/4" wide, 2" high, and 1/8" thick. This holder is the same size on the British and Aussie sets. It has a lot more stuff on it than the 19 set one has. Seeing as how there's a tablet No 1 to tablet No 5 listed, they must have had different markings on them. I looked in the manual again and the complete wireless vehicle setup just used tablets No 1 and No 2. Any thoughts on what would be on the pictured tablet? It looks like 3 rows of printing. I'll make a set of tablets out of white plastic then if I find what's printed on them I'll print out some decals.
I also noticed the plug and wires going to the Aerial Unit C. Those wires look to be pretty well 12 inches long. I have four ZA0933 cables that are 30 inches long. That's the wire that goes from the capacitor to the aerial on the truck. I'll shorten two of them to go from the set to the aerial unit Connector No 3 and one to go from the set to the capacitor on top of the set. I'll need another of the set end wire ends for the ground wire and I'll have those wiring setups complete with all the proper connectors. All the proper cables sure are hard to come by but I'm slowly getting there.
I still need a couple of Connectors N0 1 and the wire for my remote units.
I made a list of contents for the spare parts case using the font and format as close as I could get to Mike's post. I even made it slightly discoloured. The Ammeter HF 1 amp No 3 is the one used with the vehicle setup. The other ammeter I listed was used with the high power sets with the H.T. battery.