|
|
#13
30-06-16, 14:46
|
|||
|
|||
being one spline tooth out
Yes, ... that point needed emphasis. I recall you understand those fine splines very well Rob.
"Performing the speed change test may assist to determine if the CTL 4950 is bent, or simply not properly installed on the shift lever. You could place a straight edge against the long side of the adapter to visually inspect it." See also: http://mapleleafup.net/forums/showthread.php?t=8560 Last edited by Michael R.; 30-06-16 at 16:05. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tool box issue | Svenn Ryen | The Softskin Forum | 5 | 05-12-12 16:52 |
| Hard or impossible shifting out of 4x4 with C60 CMP- Tip | Phil Waterman | The Restoration Forum | 7 | 28-10-10 22:35 |
| Muck Shifting for King George | Noel Burgess | The MLU Sappers Mess | 0 | 14-06-09 00:01 |
| UC shifting issue | alleramilitaria | The Carrier Forum | 16 | 04-05-07 03:28 |
| Shifting the Tot around | Pete Ashby | The Softskin Forum | 13 | 07-08-06 06:29 |
Threaded Mode