|
|
#9
02-05-16, 12:23
|
|||
|
|||
Rich,There is a bolt in each lower corner that go into the lower engine cover rails. (see where the slots are for the rails)
The bottom of the fan circle piece sits on the shoulder of the bit under the engine bed rail forward bits. The radiator top mount (tongue) goes through the slot at the top. I can give you measurements, but not until next week. I am busy till then.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 02-05-16 at 12:29. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: radiator shroud to suit lp2 carrier | Dale Jordan | For Sale Or Wanted | 1 | 18-04-16 05:46 |
| CAB Radiator Shroud F15 | James Y | The Softskin Forum | 1 | 25-12-15 02:07 |
| 1944 wasp flamethrower bren carrier canvas shroud cover | kevin powles | The Carrier Forum | 1 | 28-07-13 18:55 |
| Radiator shroud and front section take outs. | Svenn Ryen | The Restoration Forum | 3 | 28-03-13 13:46 |
| Mk1 radiator shroud | Philliphastings | The Carrier Forum | 1 | 20-01-11 11:59 |
Threaded Mode