How To: C15a Wire-3 restoration

[Bob Carriere]

My rear wall bolts on top of the dot and dash floor plate so I will have to use a rubber gasket/antisqueak soft enough to conform to the floor plate design.

I tested the bare wall frame and the holes do line up...... for now.

Been playing with test pieces trying to roll the proper curve at each end but with a full length / full width piece it is a bitch to hold over head when doing the second curve. Hoping to have a close fit.... preshaped panel that will require minimum clamping and gluing.

Was just toooooo hot and sticky for that kind of work today!!!!

Cheers