|
|
#11
12-01-15, 12:07
|
|||
|
|||
Here's an update on my carrier , not much time as work is flat out with holiday makers here in Port . I did find some time to do all the seats two rainy days we had , I took advice from Darrin , Mick and Euan . I used HD foam 1' 1/2 inch thick for back rests with 12mm ply this works well and lets the drivers tool box open , 3 inch for seats and then folded the corners and stapled to the ply base . I'm 6'4 and skinny I still can sit in drivers seat and uses all controls
  Rear end is all finished  My NOS mirror turned up the other day . can't believe how good it looks . The paint is very close to my colour 
__________________
1944 GPW and Bantam trailer Last edited by Dale Jordan; 12-01-15 at 12:30. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 16:15 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 09:39 |
| Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 23:33 |
| How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 12:17 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 01:13 |
Threaded Mode