|
|
#11
24-03-14, 19:01
|
|||
|
|||
Just a small update:
Have found somewhere on the net that flathead's new 10 inch plate should be 3/8inch thick, which equals cca 9.5mm, new linings should be cca 3.5mm thick. Checked it on my 11´ clutch and I got 10mm overall thickness with cca 3.4-3.5mm lining thickness. It seems to be specs as new, but the rivet's heads are only 0.7mm bellow the lining surface at the minimum point - which is not too much I guess. The question is if the 11´ plate doesn't use thicker linings (4mm) than 10´ plate? Any comments? 
__________________
UCw Mk.III 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: Humber FV1601 Clutch Plate | Dave Mills | For Sale Or Wanted | 3 | 27-11-16 11:29 |
| Ford Clutch | Eric Szalanda | The Restoration Forum | 3 | 02-10-11 15:38 |
| F8 clutch - help! | david moore | The Restoration Forum | 7 | 16-01-08 05:17 |
| Chev clutch pressure plate | rampant rivet | For Sale Or Wanted | 1 | 11-02-07 17:09 |
| Chevy Clutch Pressure Plate | martineaton | The Softskin Forum | 1 | 14-09-06 09:03 |
Threaded Mode