|
|
#19
16-09-12, 13:07
|
|||
|
|||
work on the LH side plate
Commenced work on the LH side tool panel of the hull. Marked out the position on the hull side and removed the 2 broken brackets that once apon a time held vehicle tools and ground off the old welds.
Also heated and removed a broken stud on the side tool plate, it eventually came out by cutting a slot in it and unscrewing it. 1 more broken stud that would not come out with heat or persuasion. That one will wait for later, may replace the mounting block. Found 2 salvaged and blasted brackets from my parts supply and welded them in place, on the hull. Not much time to work on it this weekend. Replaced the little bracket that secures the jack handle to the side of the hull, made from 3mm steel cut at a friends place. Also measured up the mounting blocks and numbers required to be replaced, will get new mounting blocks made in the next month.
__________________
1943 Ford GPW Jeep "Follow Me" 1943 MBT trailer 1943 Dodge WC-57 Command Car 1943 Chev C60L Army Cargo Truck 1941 LP2 VR 731 Bren Gun Carrier 3" Mortar Carrying Under restoration: 1940 LP1 Bren Gun Carrier 194? 1 Ton Trl Ben Hur 1942 C15A with sunshine cabin MVPA 31338 
|
|
|
Threaded Mode