|
|
#24
07-03-12, 12:06
|
||||
|
||||
Behind-dash electrics
elec1.jpg elec2.jpg elec3.jpg
If weather is STILL bad tomorrow, I plan to continue with the under-dash electrical stuff. As you can see, the backing board is fully stuffed! I'm thinking of Masonite for a replacement. Anybody done this in the past? New resistor coming from Victoria, plus a 'spare' for the travel fault kit. elec4.jpg I bought 3 new rubber grommits for the voltage regulator while I was in town this afternoon. They are not original specs but will do OK. I have noticed my other regulator (not yet rcleaned up) has a lot more writing on the cover. I believe both are Ford, but the other one matches one seen in a photo Keith sent me recently. Might have a closer look at that tomorrow morning.
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still) Medium sized, half fake, artillery piece project. (The 1/4 Pounder) 
|
|
|
Threaded Mode