|
|
#11
12-04-11, 23:50
|
|||
|
|||
Progress on overhaul
Hi All
Over the last week or so I've been busy on the HUP over haul, disassembled and inspected transfer case, transmission, rear brake drums, and today started on the body. I've clean up and added to my overhaul web pages http://www.canadianmilitarypattern.c...20Page%202.htm No real problems with the transmission only real work was welding back a little material on the reverse lock out, which was surprisingly worn. One comment I will make to anybody planning to work on your transmission. Before you remove the cover put the transmission in the neutral position before you unbolt it and lift it off. Then take a good picture of the position of the shift forks and of the position of the gears. Saves time on reassembly because there is not a picture in most manuals. Of the 4 rear wheel bearings only one needs to be replaced as the race is slightly pitted, only one roller has a mark on it. Plan to replace the race and the bearing as a set. The pictures below though show today's project rolling the body on it's side in the bed of C60L. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
|
Threaded Mode