Wire Cutter
Derk,
After seeing the diagrams, I went down to the shop and started making the parts. Cut the plates and drilled them. Cut the short peices and put an angle to the blade. But, do to the warnings, stopped short of making them knife edge. But, I put the project on hold, I didn't have the exact angle iron, so I had to stop. Repainted the bumpers today, to get the wrong CFR numbers off. Replaced the transfer case rear seal and took the slop out of the parking brake. Cutter should be ready by the weekend. The info is very helpful.
Thanks,
Bob M.
|
13-05-10, 00:05
Threaded Mode