inquiry on Iltis

[T. Alcorn]

Scotty,
Now I know where Platemeister got the image, right from that site you posted.
The Maple Leaves on the top, are they embossed onto the plate or printed? Platemeister was going to print two maple leaves onto 3M reflective media, but, I think that would cause camouflage problems in the field. You guys deployed with these plates on the vehicles.
If he can print the maple leaves that should be good enough. I wouldn't expect them to make the embossing die unless there is sufficient demand for replica plates. Most of the vehicles were surplussed with the plates still on, right?
Should I start a separate post in the Restoration section about DND plates? Same plate design would be used for domestic M38s, M151s, Iltis, etc.
Canadian Forces in Europe have a different plate.