Carrier "RestoMod" in Oklahoma

[rossbart]

Rob & Charles,

Thanks for the comments and suggestions. I think adding some kind of deflector on the top edge is a great recommendation and I'll work on that. In addition to shedding water it would also add a bit more strength & rigidity to the front armor section (which is 'just' 1/4" plate)

I now have the left side all welded, smoothed and primed and it should be a relatively easier task of just mirror imaging the right side now. Unfortunately, due to work and a virus I haven't had much time on the carrier.

Hope to make some progress before long and will definitely post some pics.

In the meantime, I wonder if someone could just help me out with one or two measurements (please..) . Can someone let me know how deep and wide the two side air inlet boxes on a mk1 are at the top. I think I can figure out the height and angle from rivet holes in the hull, etc.. But, in particular, I cannot tell how thick it is from photos (which is all I have to go by).

Thanks for the help...

Ross