|
|
#11
10-04-19, 16:48
|
||||
|
||||
Here is the axle shaft in question. Both sides are the same. This goes from the CV joint to the hub.
E5414F7D-AEE6-4EEE-A3DB-E607390CD8D3.jpeg This is the grease slinger. My understanding is that it fits on so it sits flush against the shaft. The lip would point towards the splines. 3BDBD94F-1A0F-4F6B-822E-76B1DB00A682.jpeg Here is the original Timken #462 bearing cone. This was my concern as it has quite a loose fit. However the wear marks on the grease slinger match up to bearing surfaces. 12305F15-5A56-492F-B74E-61218B926D8A.jpeg 8CE99F0F-2E88-4F4A-923D-0CB6F6323D31.jpeg Last shot of the left side assembly all together on the bench.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode