|
|
#33
02-08-16, 15:25
|
|||
|
|||
Darryl, The pinion installation appears to be the same as on the Studebaker US6. I have some spare yokes should you need one.
As regards removal, I would definitely recommend applying a puller to the yoke then supporting one side of the parallel section of the yoke with a steel block whilst striking the opposite side with a heavy hammer. So as not to bruise the yoke place a flat steel bar against the side you are striking. Support it well and strike it hard. If at first nothing happens rotate the yoke 90 degrees and try again. I've never known this method to fail to release a tapered fitting. Dave
__________________
Hell no! I'm not that old! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ford V8 engine number - ID? | Hanno Spoelstra | The Softskin Forum | 0 | 08-04-18 15:42 |
| Ford contract number | Hendrik van Oorspronk | The Softskin Forum | 2 | 14-09-17 21:00 |
| ford t16 chassis number tracing | Joe Bowen | The Carrier Forum | 6 | 03-11-16 12:37 |
| Contract number for Ford F15A | Chris Daines | The Softskin Forum | 0 | 01-12-15 14:44 |
| Ford engine number decoder | Keith Webb | The Softskin Forum | 5 | 24-05-07 17:54 |
Threaded Mode