|
|
#21
14-10-13, 05:01
|
|||
|
|||
Dale. this is just a tease. I have the screws at home, but not heading that way until next year.
 (Shame I dont have the BSF ones for my carriers) You might have to make them from set screws (bolts that are threaded to the head)The cups you could Araldite into place (I did). If you could locate some suitable copper, you could form the heads. You need long and short ones. Here are some ebay U.K and USA bearing possibilities. Auction # 141008766719 uk cheaper. Are buget but should be good for many years. EU made. # 130573027106 usa # 190852765613 usa. These ones are angular contact, and would need to be used in pairs. Quite expensive.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 14-10-13 at 05:06. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 15:15 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
| Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 22:33 |
| How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 11:17 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |
Threaded Mode