|
|
|
|
#1
04-12-03, 13:13
|
|||
|
|||
Steel Trays for Chev C15 and Ford F15
Looking in Australia for a steel tray for my Ford F15a. I think the dimensions from memory were roughly 6.5 feet long and 7 feet wide. Can you help?
Also just had my instrument panel restored by Bob Mosely. A great job. I can recommend his work to anyone. Good job Bob.Check out the pics in the restoration forum. 
|
|
#2
04-12-03, 22:08
|
||||
|
||||
|
Steel trays
Hi Tim
There are a couple of basic trays used on SWB CMPs in Australia and there are also the Canadian ones about, a few of which were imported as complete trucks. You should find one if you're persistent, but sometimes they need a lot of work to restore due to their construction and rust problems. All the Aussie ones on both Ford and Chev were built by Holden. Here's a pic of a F15A with a correct tray:  More pics here
__________________
Film maker 42 FGT No8 (Aust) remains 42 FGT No9 (Aust) 42 F15 Keith Webb Macleod, Victoria Australia Also Canadian Military Pattern Vehicles group on Facebook https://www.facebook.com/groups/canadianmilitarypattern
|
|
#3
05-12-03, 16:42
|
||||
|
||||
|
GS bodies
Hello Tim
As Keith said , there are a number of CMP 15 cwt GS bodies around . Over the years I have seen them , the GMH built ones outnumber the Canadian examples by a long way . That is a GS no. 2 ? Keith has pictured . If you find one , more than likely it will be badly bashed about and rusty . One good thing though , the panels are flat and if you have access to the correct gear eg. metal folder and guilotine you can make up new panels . A drawback is , they used heavy gauge metal around 14 gauge which makes it more difficult . Try the local TAFE college engineering Dept. and enroll in a basic course , then you have the use of their equipment ! Good Luck Mike
|
 |
|
|
Hybrid Mode
