|
|
|
|
#1
04-02-10, 11:58
|
||||
|
||||
carrier stowage boxes
Hi all, I am in the process of making a couple of sets of carrier bins to take to corowa if anyone is interested. If there is any in particular that is required just give me a pm. The boxes are quite accurate as I am getting my measurements from originals.
Colin. 
|
|
#2
04-02-10, 12:04
|
||||
|
||||
|
The cost will be around $250 each as there is a huge amount of work involved and they will be painted.
|
|
#3
04-02-10, 21:12
|
|||
|
|||
|
Hi Colin,
Excellent work on the boxes. A couple of questions; Do they come with the latches you showed being manufactured in your other post? Will you also be making the three smaller boxes that mount in the rear compartment? I'm definately interested in a set. I'll send you further detailis in a PM. Thanks. Ian
|
|
#4
04-02-10, 22:44
|
||||
|
||||
|
tool box
Colin, as usual top quality work. Like Ian I was wondering when you are reproducing the drivers tool box.
__________________
Euan McDonald 4? C-GT (Aust) #8 44 C-GT (Aust) #9 42 Jeep, Trailer Aust 3 Welbike MK2 complete Welbike MK2 inconplete under resto C15A x3 C60S x1 ex ambo F60L x3 LP2a carrier SAR #4993. Trailer No27 Limber Trailer, Cario cargo Trailer, Pontoon semi Wiles Cooker 2 wheeled (jnr)
|
|
#5
05-02-10, 05:33
|
||||
|
||||
|
Hi Ian, they will definately have the correct latches on them and I will have some of the rear boxes as well.
Hi Euan, if I can get enough time I will make some drivers tool boxes. It just depends if I can make the die's to produce the hinges but I will do my best. regards Colin.
|
|
#6
10-02-10, 10:42
|
||||
|
||||
|
Hi everyone, just finished a couple of sets of rear boxes and ready for paint.
also finished a few clips and a pic of the other boxes I have started making for corowa which is the box that holds the stove and the pair of utensile boxes that sit behind the radio. Colin.
|
 |
|
|
Hybrid Mode
