Bearing blocks for clutch and brake controls

[Eric Szalanda]

Hi all,
I am working on the front compartment of my LP2 carrier and I am manufacturing a few things. I am now making the "Block bearing clutch & brake controls" , part numbers 520/5 and 521/5, or the floor mounts for the brake and clutch pedals. The existing ones are rusted away, typical for carriers left outside. I am after the dimensions for them. There are 2 different ones. One is taller. I need as many dimensions as possible, including the outside diameter of the shaft end, (I found a socket that was the same size and measured its diameter), inside diamater, etc. I suspect that they are the same as the English carrier, as the seat mounts are. If anyone has some good originals that they could lend me, I could make a couple extra for the use of them.

cheers