|
|
#1
02-06-19, 23:08
|
||||
|
||||
Part ID needed.
Could I get some assistance identifying this part please?
Stamped markings are GMH-W S (ie Australian made at General Motors Holdens at Woodville in SA), and A78681T-5, and 18683T, and ADD-A-5-279. Soft padding under the canvas, and is shaped offset, such it might be "handed" (ie LH or RH), and possibly only half of a pair. Last edited by Tony Smith; 02-06-19 at 23:26. 
|
|
#3
02-06-19, 23:35
|
|||
|
|||
|
Shoulder rest for a 6 pounder anti-tank gun ,also used in Armoured cars.
Rob...………..rnixartillery
|
|
#4
02-06-19, 23:36
|
||||
|
||||
|
It certainly looks like some sort of shoulder pad, but the Holden-made Polsten pics on the Holden Retiree's Club page show the Holden guns had canvas webbing for the shoulder support.
|
|
#6
03-06-19, 22:32
|
|||
|
|||
|
6-pdr
I agree with RIX: 6-pdr gunner's shoulder rest/mount.
Mike
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: 19 set part needed | peter simundson | For Sale Or Wanted | 2 | 10-11-18 01:21 |
| Help needed for part i.d. again............. | kevin powles | The Carrier Forum | 2 | 11-01-09 17:31 |
| M2 BMG part needed... | paul53 | For Sale Or Wanted | 0 | 07-02-07 04:40 |
| Hub part needed & wiring | Bryan | The Carrier Forum | 15 | 20-10-05 08:43 |
| Speedometer Part ID Needed | Bob Moseley (RIP) | The Restoration Forum | 8 | 28-02-05 10:04 |
Linear Mode
