|
|
|
|
#1
03-04-13, 09:33
|
|||
|
|||
long weekend project, track winch.
So with Easter being a long weekend I spent a few hours in the garage plasma cutting and then doing a little tidying up with the grinder, almost finished, just need to make up the center bit on the lathe at work.First photo is of the one I have on loan (cheers Alex) second photo is the wooden templates and the cut outs after a tidy up.
|
|
#3
03-04-13, 11:51
|
|||
|
|||
|
Ben
Although not correct, they would work on one of your carriers. You might want to keep it.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
|
#4
09-04-13, 09:58
|
|||
|
|||
|
Looks mint Lew. Got that pintal hook bolted on yet?
__________________
1967 Land Rover Plant Repair Vehicle 1941 Matchless G3L 194? Wiles Junior Trailer 1941 Morris Commercial CS8
|
|
#5
10-04-13, 11:24
|
|||
|
|||
|
Slow progress
Dammit ive been too busy to get anymore done. Planning on cutting the holes for the side plates on the lathe in a 4 jaw chuck when I get some spare time. Pintle hook looks good in place but not bolted on just yet.
|
|
#6
14-01-14, 04:41
|
|||
|
|||
|
took a while but it's finished
So it took a little while but finally got it finished. There was a bit of tidying up with the file and flapper disc on the grinder then bit of welding to piece it together. Talk about a brain explosion whilst trying to remember how to do an eye splice in the wire rope, didn't turn out too bad after referring to youtube. I need to take a link out of one side of the tracks as they have loosened up a little from the extra bit of riving of late.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
