CGT bearings info please

[badger1bear]

Hello, does anyone know what the modern bearing equivalents are for the front and rear axles for my CGT or where I might find some new old stock ??? any help as always is greatly appreciated

[Hanno Spoelstra]

Hi Simon, did you look up the thread "Modern part numbers for CMPs"?

Good luck,
Hanno

[chris vickery]

Simon, having worked in the industrial supply business, as well as being an avid vehicle buff and restorer, I do know that all cmp bearings have modern equivilants. If you are able to locate the maker name and specific part number, or better yet take the part number from a manual, they should cross over without any problem. At this time I don't have a cmp manual handy but Iam sure that there is a list of bearings in it.

[Barry Churcher]

Hi Simon
I will be away for a couple of weeks but when I get back I can give you the numbers. I have overhauled quite a few of these diffs and there is only one bearing that I have not been able to source. If you don't find the numbers before that give me a little nudge.
Barry

[Tony Smith]

The following numbers are Timken, but they're available also under the same numbers from NTN and I believe also SKF. If SKF have different numbers, then your supplier should also have a crossover list of numbers.

[badger1bear]

Many thanks Tony that is most excellent work, now all I have to do is get the local bearing guy to put his newspaper down and locate them for me

Many thanks Badger