Quote:
Originally Posted by Peter Duggan
Got lost on the way to the firewall and ended up working on the drivers controls. Installed a new toe plate, the original was only good for a template. Takes a bit longer bit longer but its nice to be adding parts. Cleaned up the nose armour and with some luck it will be off for sandblasting and epoxy priming tomorrow.
|
Peter, You will find that you have to remove the new toe plate again as the four nose armour bolts are behind it and you cannot tighten them up with the toe plate in place. It is also hard to fit the toe plate if the front locker is in place, so watch out for that too.
Regards Rick.