Quote:
Originally Posted by Jonathan Moore
Bruce,
I hope that these are ok.
Jon
|
Just one confirmation: is the entire height of the bracket 23-1/4" from the bottom of the bumper to the very top? If so it seems to match the 15cwt one (pic attached), the only difference being the bolt spacing on the bottom is different to allow for the thinner 5" HUP bumper.
Also, thanks to your door latch pic I was able to finish my HUW lower skin panels. Truly a job of measure twice, three or even four times to make sure you cut only once. If anybody needs to know, the steel size is 18 ga. 76-1/4" by 30-1/2" (overall) with a corner radius of 5" and 3/4" I.D. bends front and rear.