Quote:
Originally Posted by Richard Coutts-Smith
Dave, assuming that the winch fairleads are same across the range of CMP's:
The two wire rope sheaves or pulleys are un-braked and measure in at 8 3/4inch diameter, 1 1/2inch thick, mounted on a vertical pin that passes through a boss top and bottom of both sheaves. This gives an overall height of 3 3/4 inches between the two mounting plates. The top mounting plate is as you have marked, going full width under the chassis rail. There is a lower plate that retains the mounting pins, it is the width of the two sheaves combined, and is basically a wide "U" section welded to the underside of the top plate.
The bottom roller I have goes full side to side, but guessing the diameter would be the same, 3 1/2 inch.
You know there is a set of fairleads on the front bumper as well?
Rich.
|
My "pulleys" are 12" x 2" scale size...so not too far off.
Not bad for a guess.
Sometimes, a bit bigger is better for scale assembly.
I am still unclear about the second mounting plate.
The "wide U section" you refer to.
I can see part of it in my reference photos, but its still not clear to me
how it mounts, or its actual shape and size.
Its not a big concern, since I am not including every accurate detail, but...
...
"fairleads"...whats that?
You wouldn't be talking about that roller cable guide thingy?
Is that what you refer to "up front"?
...
Where is the cable guide in the rear?
Does it go here(photo)?
Something is missing (on my model) to guide the tow cable under the frame.
