CONNECTOR, Single No. C3 ZA/C 2270
Two NOS pairs of these cables arrived in this morning's Mail.
These are the interconnecting cables between the two 6 Volt Wireless Batteries that sets them up in series to provide the 12Volts DC needed for the wireless set.
One pair of these cables was issued with the basic Wireless Set No. 52 and served as the working set for the wireless. The second set was issued with the Remote Receiver Kit and when not in use, were stored in the Case Operating for the Remote Receiver.
There is an interesting production history with these cables. The ID collars on two of them have three lines of information in large font as follows:
CONNECTOR,
SINGLE #3
CMC 110-317
The other two cable ID collars read in four lines in a smaller font:
CONNECTOR,
SINGLE No. C3
CMC 110-317
ZA/C 2270
I am assuming the second set is a later production run from Marconi than the first set.
The slotted copper lugs on each end have been zinc plated and stamped on one side with:
S-90-A
David
|